Breaking strengths shown are based on the load a component or assembly will withstand before failing. WORKING LOAD LIMITS SHOWN RATED AT ONE-THIRD OF THE BREAKING STRENGTH. Unless otherwise specified, all ratings are based on a straight tensile pull. Load directions other than straight can result in a significant reduction in breaking strength.

The ratings shown are contingent upon using Kinedyne track, beams, webbing and hardware as a system. Cargo control products must be attached to securing points of equal or greater strength for break-strength rating to be maintained.

NOTE: All products shown are intended to be used as cargo securing devices. Products are not to be used for lifting purposes.

All ratings are for products in new condition. Age, wear or damage to any tie-down system can greatly reduce its strength. All products should be inspected prior to each use.

WARNING: Products may be subjected to dirt, mud, snow, ice, road salt, cleaning solution, etc., and therefore require inspection, cleaning and lubricating to ensure that they are in proper operating condition. CAUTION: Webbing straps must be protected when used on rough or sharp objects. All worn, deformed or damaged products should be removed from service immediately and replaced. All Kinedyne products shall be used in accordance with local, state, federal, and industry regulations. IT IS THE OWNER’S AND/OR USER’S RESPONSIBILITY TO EVALUATE THE SUITABILITY OF ANY CARGO SECURING PRODUCT FOR THEIR PARTICULAR APPLICATION. Failure to comply with recommended usage guidelines may result in personal injury or cargo damage, personal injury.

WARNING: The use of cheater bars or other means of increasing the leverage on a ratchet buckle handle, other than a Kinedyne approved device, can cause serious injury to the user and/or bystanders.